On site

Raghwat Al Janoub Maintenance and Cleaning

Post-construction cleaning in Al Mashael, Riyadh

Al Mashael is first and foremost an industrial area, and cleaning here after handover is a completely different job. New warehouses and factories leave oily grime and diesel soot from workshops, not simply cement dust and paint spots. Unpaved yards surround the buildings, and heavy vehicles pass through all day, coating everything in soot and soil.

Why this is not routine cleaning

  • Build residue needs more than wiping

    Cement haze and silicone lines need a scraper and the right chemical for each surface, not a cloth.

  • The right order, top to bottom

    We start at the ceiling and high vents and work down to the floor, dry before wet.

  • Glass and marble handled with care

    Riyadh's mineral dust and the region's hard water leave calcium scale on glass that scratches if you scrub hard or leave it too long.

  • Vents cleared before first use

    Building dust drifts into AC outlets and vents and lodges in the filters, so the first time the unit runs it blows that dust through every room.

Why the job is different in Al Mashael

New factories and warehouses collect oily residue on floors and metal surfaces far more quickly than ordinary residential buildings, because the surrounding workshops and vehicle routes are the constant source. The whole method is set out in our full account of post-construction cleaning.

  • Oily grime and heavy diesel soot

    Workshops and warehouses leave oily residue from machinery and equipment, with diesel soot settling on floors, walls and windows. This grime does not come off with routine wiping and needs specialist treatment depending on the surface before any wash water is applied.

  • Soil from unpaved surrounding yards

    The yards around warehouses are unmade, so fine sand and soil enter the building constantly. After cleaning, dust returns rapidly from the surrounding area, requiring special attention to doors, windows and entry points to seal them properly.

  • Continuous lorry traffic and airborne pollution

    The Eastern Ring Road and Al Kharj Road carry lorries all day, leaving tyre dust and exhaust on glass, aluminium and exterior surfaces. Cleaning here differs from residential areas because the pollution source never stops, making exterior surfaces a different challenge altogether.

What's Included

The Eastern Ring Road extension and Second Ring Road run through Al Mashael, creating continuous heavy vehicle traffic. Diesel soot, workshop grease and soil from unpaved yards accumulate on floors, entrances and metal surfaces faster than anywhere else.

  • Construction debris removed

    New warehouses and factories leave heavy building debris mixed with oily residue from machinery used during construction and site operations.

  • Cement haze removed

    Diesel soot and dust settle on all surfaces, and removing this layer requires specialist treatment depending on material type and thickness.

  • Stickers and protective film stripped

    Protective film on windows and doors here is layered under soot and grease, requiring stepped removal so no marks remain after stripping.

  • Paint spots and silicone smears

    Paint spots and silicone marks on glass and aluminium sit beneath soot layers, so removal follows surface cleaning from soot first.

  • Vents and outlets de-dusted

    Vents and outlets must be cleared of fine soil and soot before any electrical equipment or ventilation systems are switched on.

  • Final polish of the surfaces

    Final polish of concrete floors and metal surfaces comes after all oily residue and soot are removed, improving the warehouse's finish before handover.

The character of Al Mashael

Industrial area: workshops, warehouses and loading yards

Industrial area means the new building will face oily grime and diesel soot from workshops and lorries, not only cement dust. Cleaning focuses here on removing this heavy pollution before final handover, which differs entirely from residential post-construction work.

How we work

Site survey

Clear the debris

Strip residue and dust

Wash, polish and hand over

Some of our work

Photos from our team's work.

  • A tower elevation with clean reflective panels beside panels carrying dark streaks
  • Two technicians on ropes washing a faceted metal facade at night with a pressure lance
  • A crew on ropes midway down a blue glass tower topped by two masts
  • Three technicians on ropes above a curved glass roof over a building atrium
  • Five technicians on ropes cleaning the yellow and grey elevation of a medical building
  • Seven technicians in yellow helmets descending parallel ropes on aluminium cladding

What is different about South Riyadh

South Riyadh is the older, denser and more industrial side of the capital. Manfuhah, Al Shifa, Al Aziziyah, Al Dar Al Baida and Al Faisaliyah are closely built low rise blocks and small villas with shops, workshops and warehouses between them, the wholesale vegetable market sits in Al Aziziyah, and the industrial city and Al Kharj Road carry lorry traffic all day. Oily grime from workshops, diesel soot and soil from unpaved yards build up on ground floors, entrances and tiled floors faster than anywhere else in the city.

Nearby districts we cover

Questions before booking

Is cleaning a new warehouse really different from a residential villa?

Yes, fundamentally. Warehouses leave oily residue from machinery and equipment, plus diesel soot on floors and walls. Cleaning begins by removing this heavy grime before any water wash, which is not part of residential post-construction work at all.

How much soil enters the factory from surrounding unpaved yards?

Unpaved yards are a constant source of dust and sand. On windy days, fine soil enters through vents and openings even when doors are closed. Indoor cleaning therefore focuses on sealing entry points and managing air infiltration carefully.

Does soot from the Ring Road affect warehouse windows?

The Eastern Ring Road extension runs through Al Mashael, and lorry traffic leaves soot on glass and aluminium. This soot mixes with dust and requires strong removal methods without damaging new surfaces.

Do concrete floors need different treatment when covered in oily residue?

New concrete absorbs oily grime rapidly. Before washing, the surface layer of oil and soot is removed, then remaining marks are treated according to the oil type and surface condition.

Do strong winds return soil to the warehouse quickly after cleaning finishes?

Yes, especially on windy days. Dust from surrounding unpaved yards returns rapidly to floors and windows. For this reason, cleaning focuses on sealing entry points and temporarily covering vents to protect the freshly cleaned surfaces.

Do heavy cleaning machines damage new concrete floors?

No. Equipment is chosen according to floor type and surface condition. New concrete withstands standard machinery, and selection depends on site condition and the residue present.

How much does post-construction cleaning in Al Mashael cost?

It is set after we have seen the job, because the price follows the size of the place, its condition and the time the work takes. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Mashael.

Need post-construction cleaning in Al Mashael? Tell us about the place and we will tell you what it needs

We reach Al Mashael at a time we agree, and you get the full cost before we start.

Call WhatsApp