On site

Raghwat Al Janoub Maintenance and Cleaning

Post-construction cleaning in Al Arid, Riyadh

Al Arid sits on the northern edge of rapid expansion, where new villas and apartments face active building sites on neighbouring plots. The open desert to the north brings fine sand and cement dust from Banban to every surface. Post-construction cleaning here starts by stripping that sand layer before washing anything, because the water-borne dust will resettle on what you just cleaned.

Why this is not routine cleaning

  • Build residue needs more than wiping

    Cement haze and silicone lines need a scraper and the right chemical for each surface, not a cloth.

  • The right order, top to bottom

    We start at the ceiling and high vents and work down to the floor, dry before wet.

  • Glass and marble handled with care

    Riyadh's mineral dust and the region's hard water leave calcium scale on glass that scratches if you scrub hard or leave it too long.

  • Vents cleared before first use

    Building dust drifts into AC outlets and vents and lodges in the filters, so the first time the unit runs it blows that dust through every room.

Why the job is different in Al Arid

The large glazed surfaces and light stone frontages on new villas here need careful removal of hard water marks that dry onto glass and render without proper technique. The whole method is set out in the post-construction cleaning overview.

  • Sand and dust from neighbouring plots under construction

    Al Arid is ringed by active building land. North winds carry fine sand and cement dust from the Banban desert to every exposed surface and open space. Post-construction cleaning focuses first on stripping this sand load, then addressing hard water scale on glass and stone before any internal rooms are touched.

  • Luxury villas with stone and glass frontages

    New projects in Al Arid favour light stone renders and premium glazing. These materials need careful handling after construction to remove silicone traces and paint spots without scratching or streaking, especially on high-value finishes.

  • Large outdoor spaces and gardens and balconies

    Villas and apartments here sit on substantial plots with generous terraces and landscaping. Balconies and gardens collect construction sand and cement dust rapidly, and cleaning them requires methodical top-to-bottom work to prevent dust descending onto lower levels.

What's Included

Al Arid is surrounded by building projects along the Northern Ring Road, and northerly winds carry fine sand from the open desert towards Banban directly into every street and balcony.

  • Construction debris removed

    Active building plots around Al Arid generate large quantities of rubble and sand; clearing it from the district calls for systematic, thorough removal of all construction waste.

  • Cement haze removed

    Cement haze settles heavily on glass and light stone in new villas here, and needs specialised solutions to lift it without leaving residue or streaking.

  • Stickers and protective film stripped

    Protective film on windows, doors and marble in luxury villas must be stripped carefully to avoid leaving sticky residue on expensive finishes.

  • Paint spots and silicone smears

    Paint spots and silicone smears on glass and aluminium in Al Arid leave visible lines that require targeted techniques to remove completely.

  • Vents and outlets de-dusted

    Vents, outlets and terraces collect sand and dust from neighbouring construction, and clearing them comes before running air conditioning and ventilation systems.

  • Final polish of the surfaces

    Glass, stone and marble in new Al Arid villas polish to different sheens depending on the material, and the final polish reveals every remaining blemish.

Landmarks of Al Arid

Al Arid centre holds Riyadh Golf Club and Al Baijan Park, and cleaning new villas and apartments near these landmarks requires extra care because the parks and green areas attract additional dust and debris that settles on surrounding buildings.

  • Riyadh Golf Club
  • Al Baijan Park
  • Masharef Hills Park
  • Riyadh National Schools

How we work

Site survey

Clear the debris

Strip residue and dust

Wash, polish and hand over

Some of our work

Photos from our team's work.

  • A tower elevation with clean reflective panels beside panels carrying dark streaks
  • Two technicians on ropes washing a faceted metal facade at night with a pressure lance
  • A crew on ropes midway down a blue glass tower topped by two masts
  • Three technicians on ropes above a curved glass roof over a building atrium
  • Five technicians on ropes cleaning the yellow and grey elevation of a medical building
  • Seven technicians in yellow helmets descending parallel ropes on aluminium cladding

What is different about North Riyadh

North Riyadh is where the capital has grown fastest. Along the Northern Ring Road and King Salman Road, districts such as Al Malqa, Hittin, Al Yasmin, Al Narjis and Al Sahafa are largely new villas in light render, stone and glass, while the King Abdullah Financial District and the towers around Riyadh Front add curtain wall glass and marble lobbies. Beyond Al Arid and Al Qirawan the plots are still being built, so cement dust and fine sand from the open desert towards Banban settle on every surface, and the hard blended supply water leaves scale on glass and stone.

Nearby districts we cover

Questions before booking

Is post-construction cleaning essential for luxury villas here?

Yes, especially where stone and glass frontages dominate. The contractor leaves cement dust clinging to surfaces and silicone traces on glass that ordinary wiping never removes, and these are very visible on light-coloured finishes.

How do you handle sand and dust from the building sites next door?

We start by cleaning upper and outer surfaces to clear the accumulated sand and dust, then work inward. This prevents sand settling again on floors we have just cleaned inside.

What makes cleaning villas different from apartments after construction?

Villas include exterior courtyards, gardens and large terraces, and typically contain more varied materials: stone, marble, premium glass and rendered finishes that all need different care.

Does hard water leave marks on new glass?

Yes, the blended water supply in north Riyadh is mineral-heavy. When it dries on glass and stone it leaves white deposits that are hard to remove without the right approach.

How long does cleaning take on a new villa?

That depends on the villa size, outdoor area and materials used. We survey the site first to set a realistic time and method.

Should you clean balconies and gardens before the interior?

Definitely. We tackle exterior areas and terraces first because they collect the most dust and sand. Working top-down means the interior stays clean once we finish it.

How much does post-construction cleaning in Al Arid cost?

It is set after we have seen the job, because the price follows the size of the place, its condition and the time the work takes. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Arid.

Need post-construction cleaning in Al Arid? Tell us about the place and we will tell you what it needs

We reach Al Arid at a time we agree, and you get the full cost before we start.

Call WhatsApp