Call us
On site

Raghwat Al Janoub Maintenance and Cleaning

Water tank waterproofing in Al Masani, Riyadh

Al Masani in south Riyadh is an industrial district of factories, warehouses, loading yards and compounds. Tanks here face heavy water pressure from continuous industrial use and contaminated blended supply water from workshops. Oily grime, diesel soot and soil from unpaved yards build up fast on every surface. Interior sealing preserves water purity and stops the leaks that can waste thousands of litres.

Call us WhatsApp

Why a tank needs sealing, not patching

  • Water you store stays stored

    A lined tank keeps the water it holds instead of feeding a slow leak into the slab.

  • The damp stain has a cause

    The wet patch on the ceiling or wall below a tank is the symptom, and the tank is usually the cause.

  • Safe to hold drinking water

    The materials we apply are rated for potable water, so the tank is safe to drink from once it is back in use.

  • Proven before you rely on it

    We do not hand a tank back on trust.

Why the job is different in Al Masani

Water reaching tanks here is laden with grime and oils from workshops, and tanks need frequent cleaning because the supply itself brings contaminants. The whole method is set out in our notes on water tank waterproofing.

  • Industrial grime ruins both water and the tank

    Workshops and factories bring oils, soot and dust that contaminate water. A leaking tank loses clean water and may draw dirt in from outside. Sealing preserves water purity and stops inflow of contaminants.

  • Heavy continuous pressure from industrial use speeds leaks

    Industrial water use carries heavier demand than domestic supply, and tanks here fill and empty faster. This repeated pressure causes cracks more quickly. Sealing protects against this steady heavy strain.

  • A leaking industrial tank wastes hundreds of litres monthly

    In an industrial area, water loss from tank leaks is a direct cost to the budget. A single tank may lose 500 litres in a week, which adds up significantly. Sealing stops this waste completely.

What's Included

Factories and warehouses dominate the district alongside loading yards and older buildings near Wadi Hanifah. Parts of the area were built up informally without formal planning.

  • Emptied and fully dried

    Complete drainage means halting the industrial processes that depend on the tank, so advance coordination with factory management is essential.

  • Cracks and leak points surveyed

    Cracks in factory tanks are deep and numerous because of heavy continuous pressure, and inspection requires high precision and careful examination.

  • Surface prepared before coating

    Surface preparation is difficult here because tank walls are covered in grime, oils and diesel soot from workshops, so cleaning may take considerable time.

  • Waterproofing applied in coats

    Coats are applied with extreme care because any failure will affect the factory's entire production. Quality comes before speed.

  • Full curing time

    The full curing period may be longer because thorough testing and verification are needed to ensure the seal can handle heavy pressure.

  • Fill test before handover

    Pre handover testing must be comprehensive because the tank will carry heavy pressure from the first day it is returned to service.

The character of Al Masani

Industrial area: workshops, warehouses and loading yards

An industrial area means tanks must withstand heavier water pressure than domestic tanks, so the seal must be stronger and thicker to protect the tank from continuous heavy pressure and industrial use.

How we work

Look at the tank

Drain and prepare

Apply and cure

Fill, test and hand over

Some of our work

Photos from our team's work.

  • A tower elevation with clean reflective panels beside panels carrying dark streaks
  • Two technicians on ropes washing a faceted metal facade at night with a pressure lance
  • A crew on ropes midway down a blue glass tower topped by two masts
  • Three technicians on ropes above a curved glass roof over a building atrium
  • Five technicians on ropes cleaning the yellow and grey elevation of a medical building
  • Seven technicians in yellow helmets descending parallel ropes on aluminium cladding

What is different about South Riyadh

South Riyadh is the older, denser and more industrial side of the capital. Manfuhah, Al Shifa, Al Aziziyah, Al Dar Al Baida and Al Faisaliyah are closely built low rise blocks and small villas with shops, workshops and warehouses between them, the wholesale vegetable market sits in Al Aziziyah, and the industrial city and Al Kharj Road carry lorry traffic all day. Oily grime from workshops, diesel soot and soil from unpaved yards build up on ground floors, entrances and tiled floors faster than anywhere else in the city.

Other services in Al Masani

The room and the building around it are on one list.

Nearby districts we cover

Questions before booking

Is water from a tank in an industrial area safe for workers?
If the tank leaks, no. Water may carry grime and oils from workshops and factories. Sealing keeps water clean for drinking and washing.

How much water can be lost from a single leaking tank monthly?
It can reach 500 litres or more weekly, which means significant loss to the budget and waste of resources. Sealing stops this loss.

Does a factory tank need inspection before sealing?
Yes, absolutely. Heavy use and constant pressure may cause hairline cracks that are hard to spot. Inspection determines tank strength before work starts.

Can the tank be sealed while the factory keeps operating?
No, the tank must be emptied completely and removed from service. The factory may wait one or two days. Advance planning helps coordination.

Does sealing save water significantly in this industrial district?
Yes, a tank that does not leak saves hundreds of litres monthly. In an industrial setting, this means real savings on the utility bill.

Does a factory tank need special testing before handover?
Yes, testing must be thorough because the tank will face heavy pressure from repeated intensive use. Fill and inspection take longer than for domestic tanks.

How much does water tank waterproofing in Al Masani cost?
It is set after we have seen the job, because the price follows the size of the place, its condition and the time the work takes. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Masani.

Need water tank waterproofing in Al Masani? Tell us about the place and we will tell you what it needs

We reach Al Masani at a time we agree, and you get the full cost before we start.

Call us WhatsApp
Call WhatsApp