On site

Raghwat Al Janoub Maintenance and Cleaning

Post-construction cleaning in King Abdullah, Riyadh

King Abdullah is a mixed district holding spacious villas and apartments above ground-floor shops, and the new finishes here leave different residues on glass, stone and aluminium depending on the floor and the space. The commercial units below need separate treatment from the flats above.

Why this is not routine cleaning

  • Build residue needs more than wiping

    Cement haze and silicone lines need a scraper and the right chemical for each surface, not a cloth.

  • The right order, top to bottom

    We start at the ceiling and high vents and work down to the floor, dry before wet.

  • Glass and marble handled with care

    Riyadh's mineral dust and the region's hard water leave calcium scale on glass that scratches if you scrub hard or leave it too long.

  • Vents cleared before first use

    Building dust drifts into AC outlets and vents and lodges in the filters, so the first time the unit runs it blows that dust through every room.

Why the job is different in King Abdullah

Limestone dust from the nearby plateau settles on window frames and courtyards before washing, and removing it calls for chemical treatment before water touches the surface. The whole method is set out in our notes on post-construction cleaning.

  • Light stone and glass need careful handling

    Villa and flat frontages combine light render, glass and aluminium, and hard water leaves obvious spots if allowed to dry. Cement residue on stone does not come off with routine wiping or splash alone, and each material needs its own method.

  • Shared spaces between shops and homes

    Commercial units on the ground floor need different treatment than the apartments stacked above them, and shared stairwells and corridors collect construction dust from every level. The right sequence starts at the top to avoid resettling grit on freshly cleaned lower floors.

  • Vents and outlets must be cleared before use

    Air conditioning ducts, exhaust outlets and electrical sockets are clogged with cement dust, and switching on any appliance before the clean spreads the dust back across surfaces you have just finished.

What's Included

The district lies between the Eastern Ring Road and King Abdulaziz, near a hospital and private schools, and hard supply water leaves scale on light stone surfaces and glass.

  • Construction debris removed

    Villas and flats produce large volumes of rubble, brickwork and wiring, while shops may retain heavy bags of cement and waste materials that need clearing first.

  • Cement haze removed

    Limestone haze coats surfaces in fine powder that needs chemical removal before washing, especially on stone and glass that will show every water mark.

  • Stickers and protective film stripped

    Protective film on new doors and windows leaves white adhesive traces that do not respond to plain water and need targeted removal.

  • Paint spots and silicone smears

    Paint spots and silicone lines on glass and aluminium call for sharp tools and care to avoid scratching new finishes.

  • Vents and outlets de-dusted

    Electrical outlets and vent openings are filled with fine dust, and clearing them before switching on anything keeps appliances safe and working properly.

  • Final polish of the surfaces

    The final polish shows any cement or hard water stains missed earlier, and stone and glass need separate finishing methods to avoid streaks.

The character of King Abdullah

Mixed district: shops at street level with homes above them

The mixed character means ground-floor shops may still be open when work begins, so we coordinate timing to avoid disturbing customers and staff. Shared spaces and stairwells receive focused attention.

How we work

Site survey

Clear the debris

Strip residue and dust

Wash, polish and hand over

Some of our work

Photos from our team's work.

  • A tower elevation with clean reflective panels beside panels carrying dark streaks
  • Two technicians on ropes washing a faceted metal facade at night with a pressure lance
  • A crew on ropes midway down a blue glass tower topped by two masts
  • Three technicians on ropes above a curved glass roof over a building atrium
  • Five technicians on ropes cleaning the yellow and grey elevation of a medical building
  • Seven technicians in yellow helmets descending parallel ropes on aluminium cladding

What is different about North Riyadh

North Riyadh is where the capital has grown fastest. Along the Northern Ring Road and King Salman Road, districts such as Al Malqa, Hittin, Al Yasmin, Al Narjis and Al Sahafa are largely new villas in light render, stone and glass, while the King Abdullah Financial District and the towers around Riyadh Front add curtain wall glass and marble lobbies. Beyond Al Arid and Al Qirawan the plots are still being built, so cement dust and fine sand from the open desert towards Banban settle on every surface, and the hard blended supply water leaves scale on glass and stone.

Nearby districts we cover

Questions before booking

Do shops and flats get cleaned the same way?

No. Commercial units below take heavier footfall and carry different grime, and their flooring may differ from the apartments above. The sequence starts at the top and works down to the shops.

Should I leave the flats open before you arrive?

Yes, and make sure air conditioning vents, extract fans and windows are unlocked to allow airflow. Ground-floor shops may need separate access if already occupied.

Does light render need protection after cleaning?

Light stone shows marks easily, and hard water leaves white scale. We use methods safe on new render that prepare it for washing without leaving any residue.

How long for a villa or flat with both home and shop space?

Larger properties take longer because vertical spaces need separate treatment on each level. Time varies with the number of storeys and floor area.

Will protective film and stickers come off completely?

Strong protective film requires special tools to remove without scratching new glass or aluminium. Some adhesive traces need safe chemical treatment after stripping.

When can I start using electrics after the clean?

Only after the final clean is done and all surfaces and outlets are fully dry. High humidity during the clean may affect sensitive equipment.

How much does post-construction cleaning in King Abdullah cost?

It is set after we have seen the job, because the price follows the size of the place, its condition and the time the work takes. Send a photo and a description on WhatsApp and we will give you an estimate before we reach King Abdullah.

Need post-construction cleaning in King Abdullah? Tell us about the place and we will tell you what it needs

We reach King Abdullah at a time we agree, and you get the full cost before we start.

Call WhatsApp